Ambirad QUARTZ GLOW Instruction Manual download pdf (Page 10)

2. Use a minimum of 1.0mm2 H05RN-F supply

cable with 2 poles and earth and sleeve with

silicon glass fibre braided (250°C) sleeving.

The live and neutral wires must be

connected to the terminal block. See below.

3. The green/yellow wire should be connected

to the clamp marked with the earth symbol

using a suitable wire terminal. Fit cord grip

and terminal box saddle once wired.

4. Tighten the barrel nut of the compression

gland so that the rubber seal grips the

cable.

5. To prevent water

ingress, ensure that

the cover is secured

well by hand

tightening all for

screws evenly.

1.4.4 Titan range:

• Warning – this appliance must be earthed.

• The Titan series heaters are fitted with 3.0

metres of supply cable and a moulded 13A

plug therefore it is unnecessary to remove

the terminal cover plate in order to carry out

normal installation of this model.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comments to this Manuals

No comments