Ambirad QUARTZ GLOW Instruction Manual download pdf (Page 8)

1. Fix the heater assembly to the chains via the

hole in the centre of the joining bar as shown

below and ensure the heater faces directly

down when hanging.

Wall mounting three SOR 15’s ONLY

1. Securely fasten the L-shaped wall brackets

to the mounting surface using both of the

fixing holes in the short part of the bracket.

Refer to Table 1 for recommended positioning

of the heater. Please note. wall fixings are

not supplied. They should be selected to

substantially support the weight of the

installation. If in doubt contact a

professional for advice!

2. Fix the heater assembly to the brackets via

the bolt threads on the middle heater. A

serrated washer should be placed on the

threads first and the wall brackets should

prise apart in order to fit the threads in place.

3. Place a washer and a nut on the thread on

the outside of the wall brackets – both sides.

4. Fit the heater assembly to the brackets and

place a washer and nut on the bolts

protruding through the joining bars.

5. Fully tighten the nut and bolts with the heater

set at the desired angle shown below.

• SOR 15 ONLY - When vertically mounting,

ensure the mounting surface is angled so

the heater projects downwards. Do not

position the heater at an angle more than

45° and less than 30° to the horizontal as

shown below. Position the heater so the cord

is exiting the terminal box pointing down.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Comments to this Manuals

No comments