Ambirad QUARTZ GLOW Instruction Manual download pdf (Page 5)

1.3.1 Apollo range:

• The heater must be mounted in such a way

that the halogen lamp does not slant more

than 4° from the horizontal, when viewed

from the front.

• The heater is suitable for installation only on

a normally non-flammable surface. Observe

the minimum safe distance between the

heater body and inflammable surfaces

when mounting.

• Do not position the heater near to furniture

or curtains as this could present a fire

hazard.

• Refer to Table 1 for the recommended

mounting height for the heater.

• Keep out of the reach of children.

1. Separate the heater from the mounting

bracket by loosening the two nuts at the

rear of the heater.

2. Securely fasten the bracket to the mounting

surface using the fixing holes in the bracket.

3. Replace the heater on the bracket using the

nut and bolt supplied and fix in the required

angular position by tightening the fixing bolt

on the bracket. See diagram below.

Always isolate the heater from the mains supply

when adjusting the angular position

1.3.2 Sorrento range:

1.3.2.1 General

• Always allow the heater to cool before

attempting to reposition/move. Never

attempt to move the heater while it is

switched on!

• Observe the minimum safe distance

between the heater body and inflammable

surfaces and objects when mounting.

• When ceiling hanging any Sorrento heater,

ensure the minimum distance from the

ceiling is adhered to.

• Please refer to Table 1 for the

recommended positioning of the heater with

regards to minimum distances.

• When wall mounting any Sorrento heater,

secure the supply cable ensuring it is not

resting on the body or obstructing any air

vents.

• When wall mounting any Sorrento heater,

the heater should be mounted with the

terminal box at the bottom of the unit.

• Do not install the heater in a corner!

• Keep out of the reach of children.

Always isolate the heater from the mains

supply when adjusting the angular position.

1.3.2.2 Single units SOR 15/DL30/TW45

• The Sorrento heater in singular format can

be either hung from a ceiling from chains

(not supplied) or wall mounted horizontally.

In addition, the SOR15 can be wall mounted

vertically.

• When wall mounting the Sorrento heater

horizontally, do not position the heater at an

angle more than 90° and less than 30° as

shown below.

1 2 3 4 5 6 7 8 9 10 ... 19 20

Comments to this Manuals

No comments