Ambirad QUARTZ GLOW Instruction Manual download pdf (Page 7)

• When hanging from a ceiling two chains of

equal length and gauge are required and

should be selected with fixings that are more

than adequate to hold the weight of the

heater. Ensure minimum distance from

ceiling is adhered to as shown below. If in

doubt contact a professional for advice!

1. Fix the heater assembly to the chains via the

hole in the centre of the joining bar as shown

below and ensure the heater faces directly

down when hanging.

Wall mounting two SOR 15’s ONLY

1. Securely fasten the L-shaped wall brackets

to the mounting surface using both of the

fixing holes in the short part of the bracket .

Refer to Table 1 for recommended

positioning of the heater. Please note. wall

fixings are not supplied. They should be

selected to substantially support the weight

of the installation. If in doubt contact a

professional for advice! .

2. Fix the heater assembly to the brackets via

the hole in the centre of the joining bar. The

joining bars should slide inside the gap of

the two wall brackets

3. Place a bolt and washer in the hole of the

wall bracket and put a serrated washer on

the opposite side between the bracket and

joining bar. Repeat on opposite side.

4. Fit the heater assembly to the brackets and

place a washer and nut on the bolts

protruding through the joining bars.

5. Fully tighten the nut and bolts with the heater

set at the desired angle shown opposite

• SOR 15 ONLY - When vertically mounting,

ensure the mounting surface is angled so

the heater projects downwards. Do not

position the heater at an angle more than

45° and less than 30° to the horizontal as

shown below. Position the heater so the cord

is exiting the terminal box pointing down

1.3.2.4 Three SOR 15/DL30 units

• Three Sorrento heaters can be joined

together and can be hung from a ceiling from

chains (not supplied). In addition, the SOR15

can be wall mounted horizontally or

vertically. DO NOT WALL MOUNT THE

SORDL30 UNIT!

• When wall mounting three SOR15 heaters

horizontally, do not position the heater at an

angle more than 80° and less than 60° as

shown on next page.

• When hanging from a ceiling four chains of

equal length and gauge are required and

should be selected with fixings that are more

than adequate to hold the weight of the

heater. Ensure minimum distance from

ceiling is adhered to as shown below. If in

doubt contact a professional for advice!

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Comments to this Manuals

No comments